Aqua Medic cool control Manual De Instrucciones página 5

5. Technical Data
Display:
Adjustment range:
Resolution:
Adjustment accuracy:
Loading capacity of contact:
Humidity:
Power supply:
Dimensions:
6. Operation
A) ON / OFF setting (Fig. 1, No. 9)
When switched off, press briefly to switch on; when switched on, press briefly to switch off.
B) Setting the cut-off temperature
Briefly press the ▼ or ▲ key during operation, SET starts to flash on the display in front of the set value (Fig.
1, No. 2). Then press the ▼ or ▲ key to set the cut-off temperature. After this process is completed, the set
value is automatically saved within three seconds.
C) Setting the maximum fan power
Press the ▲ key for three seconds during operation, MAX appears on the display. Then press the ▼ or ▲ key to
set the desired fan power (10 - 99%). The set value is automatically saved within three seconds. If the set value
is not sufficient to achieve the desired cooling, the power has to be increased, if possible.
D) Output control
If the displayed temperature is 0.5 °C higher than the set value, a fan symbol appears and the connected fan
starts to work. When the set value is reached, the fan switches off and the fan symbol disappears.
7. Alarm
A) High or low temperature alarm
The display temperature is more than 50 °C, the fan flashes, HHH is displayed and you hear an alarm tone.
Press any key to turn the alarm off. If the display temperature is less than -20 °C, LLL appears in the display
and you hear an alarm tone. Press any key to turn the alarm off. When the displayed temperature is in the
range of -20 ~ 50 ° C again, the alarm code will disappear.
B) Sensor Fault Alarm
If the sensor has a short circuit or an open circuit fault, the connected fan will not work. Instead of the actual
temperature, EEE is displayed, you will hear an alarm tone. The alarm can only be turned off by switching off
the unit.
8. Warranty conditions
AB Aqua Medic GmbH grants the first-time user a 24-month guarantee from the date of purchase on all material
and manufacturing defects of the device. Incidentally, the consumer has legal rights; these are not limited by
this warranty. This warranty does not cover user serviceable parts, due to normal wear & tear. The original
invoice or receipt is required as proof of purchase. During the warranty period, we will repair the product for
free by installing new or renewed parts. This warranty only covers material and processing faults that occur
when used as intended. It does not apply to damage caused by transport, improper handling, incorrect
installation, negligence, interference or repairs made by unauthorized persons. In case of a fault with the
unit during or after the warranty period, please contact your dealer. All further steps are clarified
between the dealer and AB Aqua Medic. All complaints and returns that are not sent to us via
specialist dealers cannot be processed. AB Aqua Medic is not liable for consequential damages resulting
from the use of any of our products.
AB Aqua Medic GmbH - Gewerbepark 24 - 49143 Bissendorf/Germany
5
0 – 36 °C
-20 - 50 °C
0.1 °C
0.5 °C
max. 65 W
below 80%
12 or 24 V DC
120 x 62 x 28 mm
- Technical changes reserved - 10/2020/v3