Kitchen Aid 710-0003 Manual De Instrucciones página 7

3. Use a 6 mm socket and wrench or 6 mm nut driver to
remove the brass orifice from the end of gas valve. The
main burner NG orifice is located behind the LP orifice, so
no additional orifice needs to be installed.
IMPORTANT: Check that the NG orifice is properly
installed inside of the burner opening.
4. Reinsert the burner and reattach using the 2 screws or
pin previously removed. Repeat the procedure for each
main burner.
5. Position the igniters so they are 1/4" (6.0 mm) away from
each burner.
IMPORTANT: Only Main Burners have the NG orifice pre-
installed behind the LP orifice. All other burners required LP
orifice to be removed and NG orifice to be installed.
Change the Rotisserie/Infrared Burner Orifice
1.Using a Phillips screwdriver, unscrew the screws and
remove the rotisserie/infrared burner wind baffle.
A. Wind Baffle
2. Using a Phillips screwdriver, remove the screws at the
back of grill from inside the grill.
3. Remove the access cover at the back of the grill hood by
removing the 4 screws (2 screws on each side of the
rotisserie infrared burner).
4. Using a Phillips screwdriver, remove the screws holding
the spider guard to the burner.
5. Use 24 mm wrench to remove the orifice nut.
7