Safety Regulations; Maintenance And Cleaning; Putting Into Operation - EINHELL DSS 260 Manual De Instrucciones De Operación Y Mantenimiento

Anleitung DSS 260
Please note!
The power of the tool will be reduced if you use a
hose that has too small an inner diameter or
which is too long.

5. Safety regulations

Take suitable precautions to protect yourself and
your environment from potential hazards.
Never put the impact screwdriver to any use other
than that intended.
Keep pneumatic tools safe from children.
Always concentrate while you work. Do not work if
you are tired.
Use only a quick-release coupling to connect up
the air supply.
It is imperative to use a pressure reducer to set
the working pressure.
Never use oxygen or combustible gases as an
energy source.
Always disconnect the tool from the air supply
before carrying out any repairs or maintenance
work.
Use only original replacement parts.
Never allow the tool to run unloaded at full idle
speed for any length of time.
Wear the necessary protective clothing when
working with the impact screwdriver.
Wear ear-muffs and safety gloves!

6. Putting into operation

Screw the supplied plug-in nipple into the air
connection after you have wound 2 to 3 layers of
sealing tape around the thread. Plug the bit or drive
socket on the square drive and secure it with the lock
pin and the rubber retaining ring. Select the correct
direction of rotation at the selector pin.
R = reverse/release screw, F = forward/tighten
screw. Place the drive socket or bit on the nut or
screw head. Press the trigger. The air supply can be
adjusted by simultaneously depressing and turning
the air regulator. Mark 4 = max. torque, mark 1 =
min. torque. The tool is connected to the air supply
by means of a flexible pneumatic hose with a quick-
release coupling. To get the best performance out of
your screwdriver, use a pneumatic hose with an
internal diameter of 9 mm.
08.11.2001 8:56 Uhr Seite 5

7. Maintenance and cleaning

Observance of the following maintenance
instructions will ensure that this quality tool gives you
years of troublefree service. Regular lubrication is
vital for the long-term, reliable operation of your
impact screwdriver. Use only special tool oil for this
purpose. You can choose from the following options
for lubricating the tool:
7.1 By mist oiler
A complete conditioning unit includes a mist oiler and
is fitted to the compressor.
7.2 By hand
Each time before you use your impactscrewdriver,
feed 3-5 drops of special tool oil into the air
connection. If the pneumatic tool has not been used
for several days, you must feed 5-10 drops of oil into
the air connection before you switch on. Keep your
pneumatic tool in dry rooms only.
Accessories
Special oil for pneumatic
tools 500 ml
Set of drive sockets and bits
The warranty does not cover:
Wearing parts
Damage caused by an unacceptable level of
working pressure.
Damage caused by unconditioned compressed
air.
Damage caused by improper use or unauthorized
tampering.
GB
Art. No. 41.383.10
Art. No. 41.391.17
5