Leggett & Platt Simplicity 3.0 Manual De Instrucciones página 12

Reprogram Two Remote Controls for Individual
Base Operation - Bases are factory programmed
to operate individual bases. To reprogram bases
synced to multiple remote controls, perform the
following numbered procedure. Individual base
operation will result. If programming fails, initiate
the programming procedure a second time.
SteP 1
UNPLUG both bases from the electriclal power
source (if plugged in). Wait 3 minutes.
SteP 2
Plug base 1 into the electrical power source.
You now have 3 minutes to complete the
programming procedure.
SteP 3
Simultaneously press and hold the head up and foot
up buttons on remote control 1 until the backlight
flashes. Release both buttons.
Press the head up or foot up button on remote
control 1 to verify base functions and exit pairing
mode.
SteP 4
Plug base 2 into the electrical power source.
SteP 5
Simultaneously press and hold the head up and foot
up buttons on remote control 2 until the backlight
flashes. Release both buttons.
Press the head up or foot up button on remote
control 2 to verify base functions.
Independent operation is now restored. Remote control
1 operates base 1; remote control 2 operates base 2.
12
S-cape 2.0 / S-cape + 2.0 / Simplicity™ 3.0 Owners Manual 290-0010-c
® ®
remote coNtrol ProGrammiNG
REMOTE CONTROL 1
REMOTE CONTROL 2
BASE 1
BASE 2