Mark MF 1505 UP Manual De Uso página 5

Operating Instruction
●
1. After checking that all the parts are intact and complete, position the machine on flat.
2. Pour MARK fog liquid into the oil tank carefully and screw the cap. Please use the fog liquid designated by
MARK, otherwise it might do harm to the machine itself, also void the warranty.
3. Connecting the power cord. Before power on, make sure it is connected with the rated voltage.
4. Turn on the machine, it will immediately start heating up, the digital display will show "WARMING UP".
5. It takes about 4 minutes for MF 1505 UP to heat up completely . The digital display will change to " ADDR"
when it is ready. Press the on board fog button on the machine 's rear panel or the any button on the remote to
create fog. .
Instruction to digital display
●
1. MENU button: When it shows "HEAT", press "menu" button to enter the page "ADDR".
2. Up button: Increase the relevant value of each page
3.Down button: Decrease the relevant value of each page
4.Enter button: Enter or exit each page
LED color setting page
◆
When it shows "CH1" , press ENTER button to set LED color under button one. Through UP and DOWN button,
user can realize the color setting. After finished setting, press ENTER again to exit to page CH1. The LED's color
could be set to OFF, 9 colors (Co1 -Co9) and change color automatically (rand).
When set to OFF, the LED would not light up.
a).
b). 9 colors are as following:
Co 1: Red
Co 2: Green
Co 3: Blue
Co 4: Pink
After setting the above color, the LED will show the corresponding color when press the button A on the
remote (CH-1 matches with button A) .
c). Under Random mode, the LED will change color freely, the interval is 1s.
MF 1505 UP - 3 -
Co 5: Purple
Co 6: Orange
Co 7: Yellow
Co 8: Sky blue
Co 9: White
User Manual/Manual de Uso
EN