Landxcape LX835 Guia De Instalacion página 10

OUT WIRE
90
o
10
4. Complete the entire boundary wire setup
Lay down the boundary wire around the working area as the
illustration shown.
After pegging the boundry wire, please take your Landxcape
away from the charging station. Lead the boundary wire back to
the charging station, leave a length of the boundary wire (OUT-wire)
around 80cm and cut it off. Insert both wire ends into the grooves on
the charging station. Peel off the plastic skin at the end of both wires
(around 1cm), and connect the naked metal wire end of the IN-wire to
the BLACK terminal and the end of OUT-wire to the RED terminal.
NOTE: If you need to extend the boundary wire, please refer to
"Joining the Boundary Wire" in Owner's Manual for instructions.
IN WIRE
90
o
OUT
In the case of two islands that are close to each other, it would be
convenient to lay out the wire as illustrated in the picture.
Landxcape can travel freely over the boundary wire between the areas
TM
and the mowing boundary.
TM
IN
EN