Avanti ZeroWater Manual Del Propieratio página 9

FILLING THE FILTER BOTTLE WITH TAP WATER
1. Remove lid.
2. Slowly fill the upper reservoir with cold tap water. Be careful not to dump
water too quickly into the upper chamber when the lower chamber is
empty because
it may tip and spill.
3. Allow water to pass from the upper chamber through the filters to the
lower chamber. Water will be ready to drink in several minutes.
4. Test the water using the TDS meter to confirm a "000" reading.
5. If it doesn't read "000", flush the water out, check all connections and
seals.
6. Pour water through.
7. Do not over fill. The first time you fill your Filter Bottle it will take extra
water to fill the cooler reservoir. When water in the lower chamber
reaches the line marked "MAXIMUM WATER LEVEL", do not put any
more water in the upper chamber, as it may leak. The upper chamber is
not designed to be a long term reservoir.
Safety Precautions:
or of unknown quality without proper disinfection before or after the
system. Individuals requiring water of specific microbiological purity should
consult their physician. Unless notified otherwise, municipal water is
potable.
Do not use with water that is microbiologically unsafe
USE AND CARE 7