Lockncharge Carrier 20 Cart Instrucciones De Uso página 4

Carrier 20 Cart
POWER TRAY SETUP:
Skip this step if it's already installed.
If not already pre-installed, lay the power tray in
the bottom of the Cart.
Insert the four plugs into the ECO Safe Charge
Power Management Board.
Run the device cable up through the slot at the
end (corner).
Insert the remaining cables and evenly space the cables along the rubber grip cable holder.
Insert all the device adaptors into the power outlets.
Use the locating pins for correct alignment (there
are 2). NOTE: UK and US power outlets pictured
for illustration purposes. Country specific outlets
will be sent with your product.
NOTE: Do not use the first socket on the ECO Safe
Charge Power Management Board.
Pull the cable through the rubber grip cable
holder. Slide the cable along adjacent to where
the device will be placed.