weltico PAR56 Guia De Inicio Rapido página 3

EN
Installation:
This LED PAR56 lamp is compatible with most type PAR56 submerged pool projectors.
Turn off the power supply to projectors and replace the bulb following the instructions in the projector's usage notice.
NB:
Consider changing the watertight seal between the bulb and its support for a new seal then installing the
DIAMOND POWER DESIGN bulb in place of the original bulb. If you do not replace the watertight seal this
may lead to water seeping in between the lamp and its support, and consequently damage to the bulb.
If the DIAMOND POWER DESIGN bulb's power is supplied by an electronic transformer there is a risk it
may not work (contact your retailer for details).
Provide a power supply 10% higher than the power absorbed by the bulb.
For example: A power supply of 300 watts provides power for 9 bulbs 64192LB30.
9 x 30 = 270 W.
The voltage drops can be very strong on bad connections, lugs and son Loose oxidized. Measure the voltage at
the end of the cable without the bulb.
Minimum required voltage: 10.5 V.
Maximum supported voltage: 13.5V.
For optimum light in your pool, always keep the bulb as below: