Craftsman 917.20402 Manual Del Operador página 32

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TO REMOVE HOOD & GRILLASSEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Remove retainer clip and washer from
right hand pivot pin.
4. Stand in front of tractor. Grasp hood at
sides and slide left removing hood from
pivot pins and lift hood off of tractor.
5. When replacing hood, reconnect the
headlight wire connector, and reinstall
the washer and retainer clip on the
right hand pivot pin.
Hood
' Left Pivot Pin
Washer
Retainer
Clip
Right Pivot
Pin
Headlight Wire
Connector
TRANSMISSION
REMOVAL/
REPLACEMENT
Should your transmission require removal for
service or replacement, it should be purged
after reinstallation and before operating the
tractor. See "PURGE TRANSMISSION"
in
the Operation section of this manual.
ENGINE
TO ADJUST THROTTLE
CONTROL
CABLE
The throttle
control has been preset
at
the factory and adjustment
should not be
necessary Check adjustment as described
below before loosening cable. If adjustment
is necessary, see engine manual.
32

Publicidad

Tabla de contenido
loading

Tabla de contenido