Power Button - KlipXtreme UltraBoom Portable KLS-875 Guia De Inicio Rapido

Back panel
CHARGE LEVEL IS AT 25% OR LESS.
CONNECT TO AC
CHARGE LEVEL IS AT 50% CAPACITY
CHARGE LEVEL IS TA 75% CAPACITY
FULLY CHARGED
Control
This screen displays the selected input mode: Bluetooth
1. LCD display
Note: Remove the plastic protector film from the LCD display before use
Connect your USB flash drive to play MP3 and WMA music files
2. USB port
Insert your SD
3. SD card slot TM
TM
Allows the selection and control of the available audio sources: LINE-in, Bluetooth
SD , USB and tuner. The mode symbol illuminates when the selected source is
TM
playing.
MODE: Press this button to cycle through the different audio sources. As there is no
default mode assigned, the system starts playing automatically the last media source
inserted
: Plays and pauses the USB, SD
hold for 2 seconds to initiate the scanning of channels from the lowest up to the
highest frequency, and store them automatically as presets in the memory
4. Media panel
: Repeats the current playing USB or SD
(ALL)
PREV: 1. Plays the previous Bluetooth
button will tune down to the previous channel when briefly pressed.
2. Press and hold this button to decrease the volume.
NEXT: 1.Plays the next Bluetooth
will tune up to the next channel when briefly pressed.
2. Press and hold this button to increase the volume.
: Press the button to go to the previous folder.
: Press the button to go to the next folder.
EQ: Scrolls trough the diferent equalizer sound effects
Controls the overall audio level from all inputs. Turn it counterclockwise to lower
5. Master volume knob
the volume. A clockwise rotation will increase the volume level of the speaker
Increases or decreases the bass (low) frequencies of the speaker at a range between
6. Bass knob
-12dB to +12dB
Increases or decreases the treble (high) frequencies of the speaker at a range
7. Treble knob
between -12dB to +12dB
Adjust this knob to control how much of an echo effect is applied to the signal
8. Echo knob
from the wireless microphones and the microphone inputs
Controls the audio level of both wireless microphones and wired microphone Mic. 2.
9. Mic. volume knob
Controls the audio level of wired microphone Mic. or Guitar
10. Mic.1/Guitar input
The VCV switch activates the microphone talk over feature. If enabled, it prioritazes
11. Voice Control Volume
the microphone by silencing music playback when there is an announcement through
(VCV) switch
microphone. When this switch is off, the speaker volume remains constant
Accepts the input from a wired microphone
12. Mic. 2
Accepts the input from a wired microphone or guitar
13. Mic. 1 / Guitar
Connect an active (powered) speaker, a CD player, digital media player, mixer
14. Mix out and Line
or other media source to these left and right RCA output and input connectors
in jacks
Connect a CD player, digital media player, a mobile phone or other audio source
15. Aux input
to this 3.5mm stereo line-in connector
Turns the power on and off.
16. Power switch
Plug the supplied power cable in this jack
17. AC input
Accepts the connection of an external 12V battery to extend the
18. DC in
loudspeaker's run time
When only one LED is lit it means that the battery voltage is low
19. Power/Charge LED
Indicator light and volume control for wireless microphone A
20. RF A LED / Knob
Indicator light and volume control for wireless microphone B
21. RF B LED / Knob
Indicator light and button to turn the VHF wireless microphones on or off
22. VHF LED /

Power button

Description
, USB, SD
TM
®
card here to play MP3 and WMA music files
, or Bluetooth source. In tuner mode, press and
TM
®
track (ONE), repeat all of the tracks
TM
, USB or SD track. In tuner mode, this
TM
®
, USB or SD track. In tuner mode, this button
TM
®
and tuner
,
®