Listening To The Radio; Memory Recall; Cd Play - Bigben MCD11 Instrucciones De Funcionamiento

Listening to the radio

1. Turn on the unit by pressing the
2. Press the button repeatedly to select "FM" function.
Antenna: For FM reception fully extend the external FM antenna wire and adjust the direction for
optimum reception.
FM radio channels setting
Manual adjustment of channels (frequency)
• Adjust the frequency using the tuning +/- knob
Automatic channel (frequency) tracking
1. Tune to the desired radio station by using the
2. When a channel of sufficient strength has been found, tracking function will stop, or you can stop
the automatic tuning by pressing it again.
3. Repeat until you reach your desired channel.
4. Adjust the volume by rotating the VOL knob
PRESET CHANNELS (FREQUENCY)
1. Tune to your desired station according to the normal tuning procedure.
2. Press the /PROG button, then press the PRESET button to change the number where the
station will be stored. (No.1 to No.20)
3. Store the current frequency by pressing the
number.
4. Repeat the same procedure to save other desired frequencies to Memory No.1 up to No.20
Remarks:
A stored frequency can only be erased by storing another frequency in its place.
The unit can hold up to 20 preset stations.

MEMORY RECALL

Recall the stored frequencies by pressing the PRESET button to select station 1 to 20 as desired

CD Play

PLAYING A CD
1. Open the CD Door by pressing it.
2. Insert a CD with the printed side facing up.
3. Close the CD Door
4. Power on the unit by pressing the
on the LCD display.
5. The CD will automatically play from the first track.
6. Press the
7. To stop playback, press the button
REWIND/FORWARD BUTTON
While playing a CD, the
tracks at high speed.
button once to hear the beginning of the current track.
1. Press the
button two times to hear the previous tracks on the disc.
2. Press the
button to hear the next track on the disc.
3. Press the
4. Press and hold the
previous track(s). When the desired track section is found, release the
will resume.
5. Press and hold the
track(s). When the desired track is found, release the
button to momentarily pause.
.
button can be used to jump to a different track number or to scan
/
button. The current track will be scanned and will move backwards to the
button. The current track will be scanned and will move forward to the next
button.
or button and the frequency will be displayed.
/PROG button again when you get the desired
button and press it repeatedly until "CD" indicator appears
button and normal play will resume.
- EN 5 -
button and normal play