Product Introduction; Connecting The Wi-Fi Interface - Mitsubishi Electric PAC-WF010-E Manual De Instrucciones

2. Product Introduction

No item
1 WPS switch It activates WPS.
2 RESET switch It resets the system and ALL settings.
3 LED1 (Green) It shows the wireless communication state.
4 LED2 (Orange) It shows the PAC-WF010-E state.
5 LED3 (Green) It shows the local communication state.
3. Parts
Interface unit
[with connecting cable
(5-core)]
Screw for mounting
3.5×16
Screw for mounting
4×16

4. Connecting the Wi-Fi interface

(For details on each system, see the relevant instruction manual.)
● The connecting cable (5-core) connected to an ecodan unit (CN105) should be mounted at the
ecodan unit or its vicinity.
Do not install the Wi-Fi interface
inside the ecodan unit.
Cylinder unit
Mounting
cord clamp
Screw
After connecting the Wi-Fi interface to the ecodan unit, connect the Wi-Fi interface to the access point
(to communicate with the server).
For this Wi-Fi interface, the use of WPS-Push is recommended. (Refer to 6.)
1) Hold down the WPS switch on the Wi-Fi interface for about 2 seconds to activate WPS-Push.
When WPS-Push on the Wi-Fi interface is ready to communicate with the access point, LED 1
blinks at a 0.5-second interval.
2) Activate WPS-Push on the access point.
3) When WPS-Push is successfully enabled, LED 1 lights up for 5 seconds. If it failed, LED 2 lights up
for 5 seconds, so try again from step 1.
Main Causes that WPS failed are as follows.
Comunication distance (from the Wi-Fi interface to access point), access point settings
(encryption, authentication, limit of connections, etc.)
Refer to the instruction manual for more information.
4
All manuals and user guides at all-guides.com
Description
Hydrobox
Screw Mounting
cord clamp
1
2
Mounting cord
1
clamp
Fastener
1
(for bundling the wires)
1
Connecting to Cylinder unit
150 150
Connecting to Hydrobox
Screw
150 150
Screw
3
4
5
1
1