Beamz 151.242 Manual Del Usuario página 8

3. Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to avoid vibration and
slipping while operating. Always ensure that the structure to which you are attaching the unit is secure and is able to support a
weight of 10 times of the unit's weight. Also always use a safety cable that can hold 12 times of the weight of the unit when
installing the fixture.
The equipment must be fixed by professionals. And it must be fixed at a place where is out of the touch of people and has no one
pass by or under it.
4. How To Control The Unit
Four ways to operation:
A. Master/Slave operation
B. Easy sound active and Auto mode
C. Universal DMX controller
Master/Slave operation
The unit can be linked together in daisy chain as many as you need in master/slave mode to perform the great built-in
pre-programmed lighting shows triggered by music.
In Master/Slave mode refer to the DMX settings below:
Master unit: when working at Auto or Sound Control mode operation
Slave units: DMX start address MUST be set to d001.
www.beamzlighting.com