How To Use - TL Audio Fatman iTube Manual Del Usuario

How to Use

CONNECTIONS
• Before attempting to make any connections
to or from the iTube, including the iTube amp
and dock, firstly ensure that the iTube and all
connecting devices are switched OFF.
• When making connections to other devices
from the iTube, take the time to ensure that
they are correct. For instance, (L) Left to (L)
left, and (R) right to (R) right.
• Make sure connecting pins on wires are
clean and dust free and that all connectors
are inserted into the iTube fully and correctly.
• Always turn both the power switches to the
OFF position on the units when connecting or
disconnecting the iTube tube amp or the
power supply.
POWER
• Do not switch on the iTube or mains supply
until after you have connected the AC power
adaptor between them. It is recommended
that you disconnect the power supply from
the mains when the unit is in a protracted
period of non-use (when on holiday /
travelling for instance).
SPEAKERS
• When connecting speakers, ensure they have
an impedance of between 4 & 8 ohms.
• Connect the speakers to the terminals using
either the supplied speaker cable (banana
plug) or high quality, bare(stripped) speaker
wire. (Please note that if your speaker wires
are not connected properly you may hear no
sound, or if polarities are reversed, you will
hear oddities in the signal path with an
unnatural loss of bass frequencies.
• When using bare speaker wires, fit at least
1.6mm of insulation inside the speaker
terminals so that no bare wire is visible.
• Make sure the wire holders are firmly
screwed in to prevent wires from becoming
loose. If wires touch each other, the
speakers and/or iTube could be damaged.
USER MANUAL
ENGLISH
9