Settings Menu - Datamars LIVESTOCK ID Guia De Inicio Rapido

5

Settings menu

EID
New session file: create a new session file.
Reading modes
Single reading mode (left): Pressing the ON/reading button, only one EID is read (to read
another one, click the reading button again).
Continuous reading mode (right): pressing the reading button the scanner continues
reading tags until the reading button is pressed again (or time-out occurs).
Supported USB Interfaces
Turn off the reader to connect it to the PC in mass storage and open session files.
If the reader is turned ON while connected to a PC, the reader will behave as a PC
peripheral and EIDs will be sent to the PC via the USB cable at each reading. Two
interfaces are supported:
Keyboard wedge (KWG)- left: the reader is seen by the PC as a keyboard. The codes
will be displayed on the PC screen in any window where a mouse cursor is active. No
configuration on the PC is needed.
Virtual Com Port (COM) - right: the reader is connected to one of the Virtual Com Ports
of the PC and sends the codes using RS232 protocol. Codes are received on a hyper-
terminal or using Datamars S-ID software (requires a specific PC driver that can be
downloaded from www.datamars.com).
Duplicate EIDs check
X 10
No duplicates check: (icon 1). Duplicates allowed. A single EID can be recorded in the
same session file more than once.
1 2
Duplicates check: Duplicates not allowed. The reader remembers the last 10 (icon 2), 100
100 1000
(icon 3) and 1000 (icon 4) recorded in the session file. If the reader detects an EID already
stored in the session file, the EID won't be recorded twice and the duplicate icon will be
displayed on the screen.
3 4
EID format: 8 formats are available to store and transmit the EID.
EID
Audio ON/OFF: Acoustic signals can be enabled or disabled.
X
Select the arrow icon to navigate in the menu
Press the ON button to select the desired setting
Select the home icon to return to the home
menu