Functional Description - Kurtz Ersa EASY ARM 2 Manual De Instrucciones

Functional Description

6. Functional Description
2
M
A R
s a
e r
S Y
E A
Fig.
To set the extraction capacity:
After switching on, operation continues with the last set extraction capacity.
To reset the filter operating time:
To reset to factory settings:
To connect to a soldering station or a rework system:
The solder fume extraction EASY ARM 2 can be connected to the following Ersa soldering equipment:
i-CON 1 C and i-CON 2 C, i-CON VARIO 2 and i-CON VARIO 4, or an Ersa rework system.
To set the master-slave mode:
The extraction device is selectively and completely controlled via display
To disable the master-slave mode:
K
26
Unfold the front cover before reading further. The mentioned pictures
can be found on these pages.
All device settings are made via the two push buttons on the display.
Display is on the left side and display
①
when in master-slave mode, both sides can be set independently of one
another. The upper push button is referred to as button
push button as button
and inactive when they are not lit.
The following table describes the possible settings and how they are
made:
Description
By pressing and holding down button
By pressing and holding down button
The extraction capacity can be increased/decreased. Both buttons are active.
Maximum extraction capacity is reached. Beep & button
Minimum extraction capacity reached. Beep & button
Press and hold down button
Switch on the device. Wait 10 seconds/10 beeps.
Release both buttons at the same time.
Press and hold down button
Switch on the device. Wait 3 seconds/3 beeps.
Release both buttons at the same time.
Connect the interface cable (3CA10-2003) to the interface connector A or B of the soldering station or
of the rework system, and to the remote port 1 or 2 of the extraction device.
Here, display acts as the master one: Press button
①
Should display act as the master one, press button
②
You will hear 5 short single beeps and one double beep. The master-slave mode is enabled; settings
can only be made on the display of the master page.
Press and hold button
❶
5 short single beeps and one double beep. The master-slave mode is disabled and the device accepts
the settings previously used. Settings can be made on both displays again.
3BA00217 • 2019-03-12 • Rev. 3
. The buttons are active as long as they are lit
❷
, the extraction capacity is continuously increased.
❶
, the extraction capacity is continuously decreased.
❷
and button .
❶ ❷
and button .
❶ ❷
on display and button
① ❶
is on the right one. Except
②
inactive. Button
❶ ❷
inactive. Button is active.
❷ ❶
or display
① ②.
on display and button
❶ ①
on display and button
❷ ①
on display at the same time. You will hear
②
and the lower
❶
is active.
on display
❷ ②.
display
❶ on ②.
Ersa EASY ARM 2