General Maintenance; Troubleshooting - GreenWorks Tools G40TL Manual De Instrucciones

EN
FR DE ES

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake liquids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may
result in serious personal injury.
Only the parts shown on the parts list are intended to
be repaired or replaced by the customer. All other parts
should be replaced at an Authorized Service Center.
STORING THE CULTIVATOR
The following steps should be taken before storing the
cultivator for the season.
Clean dirt, grass, and other materials from the entire
unit.
Wipe the tines with oil or spray them with silicone
PROBLEM
Motor fails to start when
switch trigger is depressed.
Motor runs but tines do not
move.
IT PT NL SV DA NO
The battery is not inserted in
or connection is loose.
Household circuit breaker is
tripped.
Cultivator circuit overload
protection is tripped.
Gear train failure.
FI HU CS RU
English
lubricant to prevent rusting.
Oil the switch trigger cable and all visible moving parts.
Do not remove the motor cover.
Order new parts to replace any that are badly worn or
broken.
Store in an upright position in a clean, dry place. Store
with the handles in the extended position, or loosen
handle knobs and fold handles down. Do not allow
switch trigger cable to become pinched when lowering
the handlebar.
Store in a dry and clean place and out of reach of
children.

TROUBLESHOOTING

CAUSE
RO PL SL HR ET
REMEDY
Insert the battery into unit.
Check circuit breaker.
Let unit rest for 4 minutes,
then repeat steps to start.
Take unit to authorized ser-
vice center.
LT LV SK BG