Important Safety Instructions - Clarity AlertMaster AL10 Guia Del Usuario

Important Safety Instructions

When using your Clarity AL10, basic safety precautions should always be
followed to reduce the risk of fire, electric shock and persons including
the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Do not use this product near a bathtub, wash basin, kitchen sink or
laundry tub, in a wet basement, near a swimming pool or anywhere else
there is water.160
4. Avoid using a telephone (other than a cordless type) during a storm.
There may be a remote risk of electrical shock from lightning.
5. Do not use a telephone to report a gas leak in the vicinity of the leak.
6. Unplug this product from the wall outlets before cleaning. Do not use
liquid cleaners or aerosol cleaners on the product. Use a damp cloth for
cleaning.
7. Place this product on a stable surface. Serious damage and/or injury
may result if the product falls.
8. Do not cover the slots and openings on this product. This product
should never be placed near or over a radiator or heat register. This
product should not be placed in a built-in installation unless proper
ventilation is provided.
9. Operate this product using the electrical voltage as stated on the base
unit or the owner's manual. If you are not sure of the voltage in your
home, consult your dealer or local power company.
10. Do not place anything on the power cord. Install the product where
no one will step or trip on the cord.
11. Do not overload wall outlets or extension cords as this can increase
the risk of fire or electrical shock.
12. Never push any objects through the slots in the product. They can
touch dangerous voltage points or short out parts that could result in
a risk of fire or electrical shock. Never spill liquid of any kind on the
product.
13. To reduce the risk of electrical shock, do not take this product apart.
Opening or removing covers may expose you to dangerous voltages or
other risks. Incorrect reassembly can cause electric shock when the
1
Important Safety Instructions
appliance is subsequently used.
14. Unplug this product from the wall outlets and refer servicing to the
manufacturer under the following conditions:
A. When the power supply cord or plug is frayed or damaged.
B. If liquid has been spilled into the product.
C. If the product has been exposed to rain or water.
D. If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the
operating instructions. Improper adjustment may require extensive
work by a qualified technician to restore the telephone to normal
operation.
E. If the product has been dropped or the case has been damaged.
F. If the product exhibits a distinct change in performance.
15. Never install telephone wiring during a lightning storm.
16. Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
17. Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
18. Use caution when installing or modifying telephone lines.
19. Use only the power cord and batteries indicated in this manual. Do
not dispose of batteries in a fire. They may explode. Check with local
codes for possible special disposal instructions.
20. The apparatus shall not be exposed to dripping or splashing and
that no objects filled with liquids, such as vases, shall be placed on the
apparatus.
21. The battery shall not be exposed to excessive heat, such as sunshine,
fire or the like.
22. The MAINS plug is used as the disconnect device, which shall remain
readily operable.
E
N
G
L
I
S
H
2