ASSEMBLY
INSTRUCTIONS_____________________ __
*Please keep the owner's manual for future reference
*If you have opened the carton and removed all packages, please disregard STEP 1. See
STEP 1
Unpack and identify all parts using the parts list provided.
STEP 2
(1) Check each part before using the
product. Make sure the gas
supply system is turned "OFF"
before assembling. See Figure I.
(2) Locate the battery and remove
the plastic cover first. Unscrew
the rubber cap of the Electric
Igniter; place an AAA battery into
the battery case. Make sure the
positive pole ("+") is towards the
cap. Screw the cap back to the
battery case tightly. See Figure II.
(3) Place the lava rocks (6 kgs)
evenly in the fire table on the top
of the fire table. See Figure III.
(4) Open the door and put the gas
tank in the metal stand. Make
sure the gas tank sits on the
metal stand completely. Turn the
wing screw on the outer part of
metal stand clockwise to secure the gas tank tightly. To close the door, insert the
bottom of the door into the base of body. Make sure the bracket at the top of the door
clicks in. See Figure IV.
See "LP (Liquid Propane) gas supply connection" section for tank connection.
WARNING
** DO NOT COVER THE IGNITION
SCREEN when placing the lava rocks
into the fire table. Always keep
Ignition Screen visible. This screen
must be clear and free of obstructions
at all times to insure proper operation.
The burner of the fire table must be
covered by lava rocks completely.
Otherwise the flame may be
extinguished partially. See the Figure
CORRECT and INCORRECT for
reference.
STEP 2 directly.
:
6
CORRECT
INCORRECT