190216
GAS CYLINDER
The maximum diameter and the maximum height of the cylinder is 310 mm and 500 mm as shown in (Fig.1).
Fig�1
Key
1: maximum diameter
2: maximum height
The gas cylinder should not be dropped or handled roughly! If the barbecue is not in use, the cylinder must be disconnected.
Replace the protective cap on the cylinder after disconnecting the cylinder from the barbecue.
Cylinders must be stored outdoors in an upright position and out of the reach of children. The cylinder must never be stored
where temperatures can reach over 50°C. Do not store the cylinder near flames, pilot lights or other sources of ignition.
DO NOT SMOKE.
Pay attention when putting the cylinder to the cylinder hole, ensure the hose connected to the cylinder does not touch the
hot surface-heat-resisted plate. Make sure the cylinder stays in place during operation. Never put a spare cylinder in the
same cylinder enclosure. Never block access to the cylinder valve.
Warning: Shut off the gas cylinder if you smell gas.
CLEANING AND CARE
CAUTION: All cleaning and maintenance should be carried out when the barbecue is cool and with the fuel supply turned
OFF at the gas cylinder.
CLEANING
"Burning off" the barbecue grill bars after every use (for approx 15 minutes) will keep excessive food residue to a minimum.
OUTSIDE SURFACE
Use mild detergent or baking soda and hot water solution. Non-abrasive scouring powder can be used on stubborn
stains, then rinse with water.
If the inside surface of the barbecue lid has the appearance of peeling paint, baked on grease build up has turned to
carbon and is flaking off. Clean thoroughly a strong hot soapy water. Rinse with water and allow to completely dry.
NEVER USE OVEN CLEANER
INTERIOR OF BARBECUE BOTTOM
Remove residue using brush, scraper and/or cleaning pad then wash with a soapy water solution. Rinse with water and
allow to dry.
PLASTIC SURFACES
Wash with a soft cloth and hot soapy water. Rinse with water. Do not use abrasive cleaners, degreasers or a concentrated
barbecue cleaner on plastic parts.
COOKING GRID
Use mild soapy water. Non-abrasive scouring powder can be used on stubborn stains then rinse with water.
1 1
PRO6 burner +S deluxe Operating manual EN-DK.indd 11
19-02-16 12:50