Royal Sovereign ARP-9009TL Manual Del Propietário página 7

C. Install the Window Slider Kit : Fig 3.
1. Open the window and place the Window Slider Kit on the inside edge of the window.
2. Adjust the Window Slider by adjusting it to the width of the window.
3. Close the window to secure.
4. Tighten the two screws to lock the window slider in place.
FUNCTION OF THE WATER TANK
This Portable Air Conditioner can run with or without water tank.
The water tank is an auxiliary function to the unit and can run with or without it. Its purpose is to use fresh water to cool the condenser so the machine will have maximum
performance. In normal conditions, it will recycle the humidity that is collected to cool the condenser and evaporate the water out the exhaust. In areas where humidity levels are
low, this tank will assist the unit in cooling effectively.
When used, you can achieve maximum BTU performance and the air conditioner will run more efficiently.
NOTE: This feature will not add humidity back into the room.
Step 1: Lift up and pull to remove the tank
Step 2: Remove the nozzle by turning counter clockwise
Step 3: Fill the tank with water to approximately the half way
level and replace the nozzle snug.
Step 4: Place the tank back into place by lining up the tank
with the tab on the back of the air conditioner
Fig 3.
7
ARP-9009TL / 9011TL