Cleaning And Maintenance - Suavinex ST060 Manual De Instrucciones

3.2. MICROWAVE STERILISING:
(without the basket for the small size)
1- Remove the lid (B), rack (D), basket (E) and electrical unit (H).
2- Fill the tank (L) directly with the 200 ml of cold water. (FIG C)
3- Replace the rack (D) and the lid (B), making sure that all the parts are correctly fitted and cannot move
around. Do not place more bottles in the steriliser than those recommended by the manufacturer and do not
force them against each other once they are inside.
4- Choose the sterilising time according to the power of the microwave before starting the cycle (see table).
5- Remove the steriliser from the microwave carefully, bearing in mind that it could burn you.
6- Before removing the lid (B), wait for a few minutes for the steriliser to cool down.
7- Remove accessories carefully using the tongs (M).
8- Discard any remaining water, rinse the base (L) and leave it to dry.
Fig C
DURACIÓN DE LA
POTENCiA
ESTERILIZACIÓN
1250W-1800W 2min
1100W-1200W 3min
850W-1000W 4min
500W-800W 6min
· imPORTANT:
- Make sure the inside of the microwave is clean and dry before starting the cycle.
- In microwave ovens with a grill, make sure it is switched off and has cooled down if it has been used previously.
- Take extra care when the steriliser does not rotate inside the microwave. If it does not rotate, the bottles could be
damaged.
- Do not place non-microwave safe products inside the steriliser.

4. CLEANING AND MAINTENANCE

The following recommendations will help you clean and
maintain the steriliser properly.
· imPORTANT:
Switch off the appliance, unplug the power supply cable and
leave it to cool completely before carrying out any cleaning and/
or maintenance tasks.
CLEANING THE WATER TANK (H), RACK (D) AND LID (B):
- Wash with soap and water then rinse clean. Do not use
aggressive cleaning products containing chlorine or its
compounds.
- Due to the salts in water, it is normal for limescale to form in
the tank. Limescale can build up quite quickly depending on
the hardness of the water and the frequency with which the
steriliser is used. Limescale reduces the steriliser's performance
TiEmPO DE
and can prevent it from working properly. The following
ENFRiAmiENTO
recommendations will help avoid this:
2min
1- Fill the tank (H) with tap water.
2min
2- Rinse several times so that the water reaches every side,
being careful not to get the power supply cable (K) or the ON/
2min
OFF button (I) wet.
2min
3- Gently clean the heating unit in the centre of the electrical
unit (H), trying to remove any limescale.
4- After pouring out any remaining water, fill the water tank (H)
with a solution consisting of one part water, one part vinegar. Fill
the tank up to the mark.
5- Replace the lid (B) and leave to act for at least 4 hours.
6- Gently swirl the appliance around for a few minutes and
remove any remaining limescale with a cloth.
7- Rinse the water tank (H) several times with tap water.
8- Leave to drain and dry all wet parts (inside and outside) with
a soft cloth.
9- If the appliance is not going to be used for a long period after
cleaning, dry all its parts. Then store it in a dry, well-protected place.
EN - 51