Installing The Motor; Connecting To Power Source - Porter Cable 7518 Manual De Instrucciones

INSTALLING THE MOTOR

1. Loosen the clamp screw (A), Fig. 1, to allow the power unit to be set in the
base unit.
2. Insert motor unit into base aligning lower pin (B) with groove in base.
3. Rotate motor unit CLOCKWISE into base until upper guide pins are rigidly
set in the groove of the base.
4. Tighten clamp screw firmly.
ADJUSTING DEPTH
OF CUT
Disconnect tool from power
source.
1. Loosen clamp screw (A)
Fig. 3.
2. While holding base (E),
turn motor unit (F), Fig. 3,
COUNTERCLOCKWISE
until the tip of the bit is
above bottom surface of
base.
3. Set router on flat wood
surface.
4. Turn motor unit (F), Fig.
3, CLOCKWISE until
bit touches the wood
surface.
5. Tighten clamp screw (A)
Fig. 3.
6. Rotate depth adjusting
ring (B), Fig. 3, until the zero-line (C) is opposite the index line (D) on the
housing.
7. Loosen clamp screw (A), Fig. 3.
8. Tip the router so bit is clear of the wood surface. Turn motor unit (F),
Fig. 3, CLOCKWISE until the index line (D) on the motor housing reaches the
desired depth indicated on the ring.
9. Tighten clamp screw (A), Fig. 3, firmly.
NOTE: Setting the index line to 1 /4" on the ring means the cutting edge of the bit
is exposed 1 /4" below the base.

CONNECTING TO POWER SOURCE

the power circuit is the same as that shown on specification plate of the
router.
Disconnect tool from power source.
Fig. 3
B
A
Before connecting router to power source ALWAYS MAKE
SURE SWITCH IS IN THE "OFF" POSITION. Also check that
10
F
D
C
E