Extension Cords; Safety Symbols; Service Safety - Sears Craftsman 320.10870 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EXTENSION
CORDS
Use a proper extension cord. ONLY use cords listed by Underwriters Laboratories
(UL). Other extension cords can cause a drop in line voltage, resulting in a loss of
power and overheating of 1ool. For this tool an AWG (American Wire Gauge) size of
at least 14-gauge is recommended for an extension cord of 25-ff. or tess in length_
Use 12-gauge for an extension cord of 50-ft. Extension cords 100-ft. or longer are not
recommended.
Remember, a smaller wire gauge size has greater capacity than
a larger number (14-gauge wire has more capacity than 16-gauge wire; 12-gauge
wire has more capacity than 14-gauge), When in doubt use the smaller number.
When operating a power tool outdoors, use an outdoor extension cord marked
"W-A" or "W"o These cords are rated for outdoor use and reduce the risk of electric
shock.
_CAUTION:
Keep the extension cord clear of the working area. Position
the cord so that it will not get caught on lumber, tools or other obstructions
while you are working with a power tool.
I Z_WARNING:
Check extension cords before each use. If damaged
replace immediately. Never use tool with a damaged cord since touching the
damaged area could cause electrical
shock, resulting in serious injury.
SAFETY SYMBOLS
FOR YOUR TOOL
The label on your tool may Include the following symbols.
V .......................................................................
.Volts
A........................................................................................
Amps
Hz ......................................................................................
Hertz
W ..........................................................................
VVatts
mln ........................................................................
Minutes
,._ .....................................................................................
Alternating current
..................................................................................
Direct current
no ........................................................................
No-load speed
[] ....................................................................
Class li construction, Double Insulated
_Jmin
..............................................................
Revolutions or Strokes per minute
Z_" ......................................................................
Indicates danger,warningorcaution
It means attention! Your safety is involved.
SERVICE SAFETY
1. If any part of this saw is missing or should break, bend, or fail in any way;
or should
any electrical component fail to perform properly: SHUT OFF
the power switch and remove the saw plug from the power source and have
the missing, damaged or failed parts replaced BEFORE resuming operation.
2. Tool service
must be performed only at a Sears Parts and Repair Center.
Service or maintenance
performed by unqualified personnel could result in
a risk of injury.
3. When servicing
a tool, use only identical
replacement
parts. Follow
instructions
in the maintenance
section
of this manual. Use of unauthorized
parts or failure to follow maintenance instructions may create a risk of electric
shock or injury.

Publicidad

Tabla de contenido
loading

Tabla de contenido