Tripp-Lite SNMPWEBCARD Manual De Instalación página 5

Installation
3-3
Insert SNMPWEBCARD in Accessory Slot: Use a screwdriver to remove the
accessory slot cover from the UPS. While the UPS is turned on, align the
SNMPWEBCARD with the guides in the accessory slot and push the card into the
slot until the ports are nearly even with the rear surface of the UPS.
3-4
Connect SNMPWEBCARD to Computer: Use the mini-DIN to DB9 serial cable
(part number 73-1025) included with the card to connect the card to the computer.
The circular connector
serial port on the card. (Align the connector carefully to avoid damaging the
B
pins.) The DB9 connector
serial port .
D
A
B
3-5
Connect SNMPWEBCARD to Network: Connect a standard Ethernet patch cable
to the RJ-45 Ethernet port on the card. Note: This port is not compatible with PoE
(Power over Ethernet) applications.
3-6
Configure SNMPWEBCARD in Terminal Mode: After a brief pause, an
initialization page should appear in the terminal emulation program. Press any key on
the keyboard within 10 seconds to change the card's settings. (If the 10-second period
has elapsed, you can reboot the card by removing it and then re-seating it in the
accessory slot.)
at one end of the cable attaches to the 8-pin mini-DIN
A
at the other end of the cable connects to the computer's
C
5
D
C