Know Your Snow Thrower; Important; Stopping Engine - MTD products 140 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SECTION 3: KNOW YOUR SNOW THROWER
Discharge Chute
Shave Plate
Auger
This unit runs on a mixture of gasoline

IMPORTANT:

and oil. Do NOT operate the snow thrower without first
reading the Tecumseh Engines operator's manual for
instructions regarding proper fuel and engine oil.
Choke Lever
OFF
CHOKE
Activating the choke control closes the choke plate on
the carburetor and aids in starting the engine. Refer to
the engine manual packed with the snow thrower for
more detailed instructions regarding the choke.
Primer
Depressing the primer forces fuel
directly into the engine's carburetor to
aid in cold-weather starting. Refer to
the engine manual packed with the
snow thrower for more detailed
instructions regarding the primer.
Ignition Key
The ignition key must be present
and placed in the "ON" position for
the engine to start.
Starter Handle
The starter handle is used to manually start the engine.

Stopping Engine

Turn ignition key to OFF position and remove it
from the snow thrower.
Spark
Plug
Cover
Starter
Handle
Choke Lever
Upper Handle
Electric Starter Button
Pressing the electric starter button engages the
engine's electric starter when plugged into a 120V
power source
Electric Starter Plug
Requires use of a two-prong outdoor extension cord
(packed with the snow thrower) and a 120V power
ON
source/wall outlet.
Spark Plug Cover
Remove the spark plug cover to access the engine's
spark plug located beneath it.
Chute Directional Control
Located on right side of dash panel, the chute
directional control determines the direction that snow
will be discharged. Crank it clockwise to discharge
snow to the left; counterclockwise to discharge snow to
the right.
Auger
When engaged, the augers rotation picks up snow that
enters the auger housing and throws it out the
discharge chute. The rubber paddles on the augers
also aid in propelling the snow thrower as they come in
contact with the pavement.
Auger Control Handle
Located on the upper handle, the auger control handle
is used to engage and disengage drive to the auger.
Squeeze the control handle against the upper handle to
engage the auger; release it to disengage.
7
Primer
Ignition Key
Control Handle
Chute Directional Control
Electric Starter Plug
(If So Equipped)
(If so equipped)
(If so equipped)
Fuel Cap
Electric
Starter
Button
(If So Equipped)

Publicidad

Capítulos

Tabla de contenido
loading

Productos relacionados para MTD products 140

Este manual también es adecuado para:

150e162e172

Tabla de contenido