Troubleshooting - Facom BC1215 Guía De Instrucciones

16.

TROUBLESHOOTING

PROBLEM
Battery connectors do
not spark when touched
together.
The charger will not turn on
when properly connected.
I cannot select a language
on the display.
Green LED is lit and the
display shows ANALYZING
BATTERY.
Green LED is flashing and
the display shows CHARGE
ABORTED - BAD BATTERY.
The display shows
CONNECT CLAMPS.
The display shows
EXTERNAL BATTERY
VOLTAGE TOO HIGH.
17. SPECIFICATIONS
Input ........................................................................................230V AC~50Hz, 2.5A / 1.8A
Output ...........................................................................................12V
18. LIMITED WARRANTY
Type D = 2 years. See the general conditions in the FACOM catalogue or the FACOM price list.
POSSIBLE CAUSE
The charger is equipped with an
auto-start feature. It will not supply
current to the battery connectors
until a battery is properly
connected. The connectors will not
spark if touched together.
AC outlet is dead.
Poor electrical connection.
Press the button for 5 seconds to
select a language:
(EN→ DE→ FR→ ES→ IT).
The charger needs to check the
condition of the battery.
The capacity of the battery is too
large for the charger.
The battery voltage is still below
10V after 2 hours of charging.
The clamps are not making a good
connection.
The fuse is bad. Ring connectors
only.
The external battery voltage is more
than the unit with power supply
mode.
21
SOLUTION
No problem; this is a normal
condition.
Check for open fuse or circuit
breaker supplying AC outlet.
Check power cord and extension
cord for loose fitting plug.
No problem; this is normal.
The green LED will be lit when the
charger is checking the condition
of the battery. This is normal.
You need a charger with a higher
amp rate.
Have the battery checked.
Check for poor connection at
battery and frame.
Replace the in-line fuse for the ring
connector.
Replace the external battery.
15A / 12V 10A