Command And Display Elements; Description Of The Commands - KNX Chorus GW 16 974CB Manual De Instalación

GENERAL DESCRIPTION

Command and display elements

10
5
6
1

Description of the commands

BACKLIT TOUCH COMMANDS
SET button key: parameter setting mode input
MODE button key: operating mode selection or value confirmation
Selection of pages (in normal operation) or parameters (in parameter setting mode)
BACKLIT CIRCULAR TOUCH SLIDER
A circular sliding slider for selecting the value to assign to the selected parameter. The circular
light guide that illuminates the sliding area, which changes colour during the heating/cooling
activation phase or based on the function performed by the parameter being modified (red for
heating and light blue for cooling)
REAR-PROJECTION DISPLAY
Display for viewing: room/setpoint temperature (°C/°F), relative humidity (%), operating hours
and parameters
Operating mode: antifreeze/high temperature protection
Operating mode: economy
Operating mode: pre-comfort
Operating mode: comfort
Not used
Temporary setpoint forcing: active
Type of operation: setpoint
Type of operation: setpoint
Fan-coil speed: automatic
Fan-coil speed: V1, V2, V3
11
7
8
9
2
17
14
15
13
12
3
E
N
G
L
4
I
S
H