Klarstein 10028291 Manual Del Usario página 6

4. Insert the remote con-
trol receiver between the
bracket and the ball joint.
7. Fasten the blade to the
motor with the screws and
spring washers already at-
tached to the motor.
10. Install the light bulb (max
60W E14 not supplied) to
the lampholder.
5. Connect the wires from
the earthed mains supply
to the terminal block.
8. Connect the light kit by
clipping together the two
plastic male/female con-
nectors.
11. Install the lampshade onto
the shade gallery by rotating
the lampshade clockwise.
6. Slide the slots on the can-
opy onto the screws at
either end of the mount-
ing plate, secure with the
four screws, spring wash-
ers and star washers pro-
vided.
9. Fit the shade gallery to the
shade gallery mounting
bracket by using the three
light kit-fixing screws and
star washers. Ensure that
you do not trap any wires.
6