Manual Programming - Emtek Assa Abloy LISCIO Guía De Instalación Y Manual De Usuario

Manual Programming

The lock can be programmed manually using the keypad buttons 1 through 5. This feature is made available but
programming using a smart phone is highly recommended.
Manual Programming Commands
1
To enter programming mode – press the #1 and the #5 buttons simultaneously
2
Enter the lock's 6 digit master code (the master code will be on sticker on back cover page and inside trim plate of lock)
3
The features below now accessible by entering a combination of two buttons one after the other (not simultaneously)
If You WishTo
Add a code
Delete a code
Change master code
Turn ON Deny Users
Turn OFF Deny Users
Deny Users can disable or enable all user codes – when ON, no user codes will work, only key operates lock
Delete all codes
Set 4 digit code length
Set 6 digit code length
Turn Beeper ON
Turn Beeper OFF
Turn Extended timeout OFF
Turn Extended timeout ON
Extended timeout mode allows for a longer duration of unlock time upon entry of a valid user code.
Turn Passage switch OFF
Turn Passage switch ON
Passage switch mode ON, choose between Passage (lock unsecured) and Privacy
Restore Factory Defaults
Press Button
# 1 and then # 3
# 4 and then # 3
# 3 and then # 3 again
# 4 and then # 1
# 5 and then # 1
# 5 and then # 5 again
# 5 and then # 2
# 5 and then # 3
# 1 and then # 1 again
# 1 and then # 2
# 2 and then # 1
# 2 and then # 2 again
# 3 and then # 1
# 3 and then # 2
(always locked) and OFF lock is always in Privacy (always locked).
enter # 1 and then # 4
Actions
Then enter new code and enter again to confirm (factory
setting is 4 digit mode)
Then enter code to delete and enter again to confirm
Then enter new master code and enter again to confirm
(factory setting is OFF)
(factory setting is 4 digits)
(factory setting is ON)
(factory setting is OFF)
(factory setting is ON)
enter master code to confirm
EN EN EN
13