Installing Batteries - Textron Greenlee FI-100 Manual De Instrucciones

Identification
1
2
3
1. Direction Indicator
2. Relative Core Power Display
3. Clamping Button
4. Sun Shield
5. Battery Indicator
6. Tone Detect Indicators

Installing Batteries

Observe correct battery orientation when installing in the FI-100.
Failure to do so may cause permanent damage.
–
+
Operation
Making a Measurement
1. Select the appropriate fiber adapter for the type of fiber to be
measured (250 µm, 900 µm, 2 mm, and 3 mm) and insert it into the
4
fiber identifier. The adapter will lock into place once guided into the
aligning slot.
5
6
2. Insert the fiber in the fiber clamp groove (250 µm, 2 mm, and 3 mm)
or onto the center of the rubber pad for the 900 µm adapter. Be sure
that the fiber does not get pinched or stressed within the housing.
Also make sure that the fiber is not pulled, bent, or stressed abnor-
mally within the fiber enclosure or access box. Excessive stress on
the fiber may cause measurement errors.
3. Slide the clamping button up to the locking position.
4. If an optical signal is present in the fiber, the appropriate directional
LED will indicate the traffic's direction along with an intermittent
audible tone. The relative core power will be also displayed. A "LO"
display indicates that there is no measurable power transmitted in
the fiber. If a modulated tone is present on the test fiber, the appro-
priate LED will illuminate and a constant tone will be emitted.
5. Push the fiber clamp up slightly to release the fiber from the
clamping mechanism.
Battery Power Indication
+
• LED Green – Battery power is OK.
• LED Yellow – Battery power is low but is sufficient to complete
the measurement.
–
• LED Red – Replace the battery.
www.greenlee.com
4455 Boeing Drive • Rockford, IL 61109-2988 • USA • 815-397-7070
An ISO 9001 Company • Greenlee Textron Inc. is a subsidiary of Textron Inc.
Normal Use and Maintenance
• The fiber must be inserted into the appropriate adapter and within
the groove or designated area for accurate measurements. If the fiber
is bent, twisted, or strained within the FI-100 housing, excessive loss
and possible fiber damage may occur.
Align adapter
on slot
and slide into
position.
• Use the lint free swabs to clean the detector surface for optimum
performance.
• Remove the batteries when the FI-100 is not in use for extended
periods of time to prevent accidental battery discharge or damage.
USA Tel: 800-435-0786 Canada Tel: 800-435-0786
Fax: 800-451-2632 Fax: 800-524-2853
Make sure that the 2 mm, 3 mm, and 250 µm
fibers are aligned in the fiber adapter groove.
Center the 900 µm fiber
on the fiber adapter pad.
Clean the two large
area detectors with
lint-free swabs.
International Tel: +1-815-397-7070
Fax: +1-815-397-9247