Battery Charger; First Use - Midland canicom BEEPER ONE PRO Manual De Instrucciones

BATTERY CHARGER

The charger comes with two slots to simultaneously charge
both the remote control and collar.
Insert the charger plug in a wall socket and the other end in
the charger socket.
Insert the remote control and collar turned off in the charger
so that they are fi rmly housed within.
Collar and remote control status LED (on the left) start
to blink.
WARNING: Both the collar and remote control must be turned
off to be charged.
WARNING: The collar and charger cases are marked with
white arrows to indicated insertion direction (the two arrows
must match).
WARNING: To correctly insert the remote control in the charg-
er, widen the strap clip and fi rmly push down.
The devices must be charged for at least 7/8 hours before
fi rst use.
About 6/7 hours are required for full charge according to de-
vice charge levels.
To avoid damages to the
unit, we recommend to use
the power supply only in
rooms fi tted with protection
devices against excessive
current, short-circuits and
earth faults.
12

FIRST USE

Before the fi rst use, we recommend you make a complete
charge of the collar and remote control (see chapter "BAT-
TERY CHARGER") and pair both devices (see chapter "PAIR-
ING A COLLAR TO THE REMOTE CONTROL").
Basic settings (volume, sensitivity, etc.) are calibrated for
standardworking conditions.
At the end of each use, any changed settings will be saved in
the memory when the devices are turned off.
WARNING:we recommend you program settings with the col-
lar nearby (under 100 metres away).
TURNING ON THE REMOTE CONTROL AND
COLLAR
First turn on the remote control by holding down the green
button ; a beep will confi rm that the device is on and the
led at the bottom will blink one to four times to indicate the
battery charge level.
Once: battery low
Twice: battery half charged
3 times: battery charged
4 times: maximum battery charge
The collar numeric led will blink to indicate which collar was
selected (the collar is still off).
To turn on the collar:
› Quickly shake the collar (to turn off energy savings mode if
still for more than ten minutes)
› Hold down button on the remote control. A confi rmation
beep will sound on both the collar and remote control to
confi rm on status; the collar number led will stop blinking
and remain on.
› When turning on, the signal LED on the collar will blink be-
tween one and four times to indicate the battery charge lev-
el (like for the remote control).
› After this signal, the status LED light will turn on.