Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
NAPDH11/NAPDH11L
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS
WARNING
serious injury or death if you do not follow the instructions.
CAUTION
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING
FOLLOW THE FOLLOWING INSTRUCTIONS CAN RESULT
IN SERIOUS PERSONAL INJURY, DAMAGE TO EQUIPMENT
OR VOIDING OF FACTORY WARRANTY. It is the installer's
responsibility to make sure all components are properly
assembled and installed using the instructions provided.
READ ALL INSTRUCTIONS BEFORE USING THIS
PRODUCT!!!!
DANGER:
ELECTRIC SHOCK:
1.
Use only in dry locations indoors.
2.
Do not plug into another relocatable power tap.
3.
This device features an internal protection that will
disconnect the surge protective component at the end of its
useful life but will maintain power to the load - now
unprotected. If this situation is undesirable for the
application, follow the manufacturer's instructions for
replacing the device.
2
alerts you to the possibility of
alerts you to the possibility of
:
FAILURE TO READ AND
TO REDUCE THE RISK OF
4.
Do not install this device if there is not at least 10 meters
(30 ft) or more of wire between the electrical outlet and the
electrical service panel.
5.
The input plug of this power tap is intended to serve as the
disconnect device, it shall be easily accessible and
withdrawn.
6.
This surge arrester does not contain internal Circuit Breaker
protection; INSTALLER MUST ensure that the input of this
surge arrester is connected individually to an electrical
service panel that is protected with a UL Listed 20A
(Minimum) Circuit Breaker for overload protection of the
surge arrester.
7.
All doors and accessories must be grounded.
CAUTION
and property damage!
1.
Elevated Operating Ambient - If installed in a closed or
multi-unit rack assembly, the operating ambient
temperature of the rack environment may be greater than
room ambient. Therefore, consideration should be given to
installing the equipment in an environment compatible with
the maximum ambient temperature (0-40°C/32-104°F)
specified by the manufacturer.
2.
Reduced Air Flow - Installation of the equipment in a rack
should be such that the amount of air flow required for safe
operation of the equipment is not compromised.
3.
Circuit Overloading - Consideration should be given to the
connection of the equipment to the supply circuit and the
effect that overloading of the circuits might have on
overcurrent protection and supply wiring. Appropriate
consideration of equipment nameplate ratings should be
used when addressing this concern.
4.
Reliable Earthing - Reliable earthing of rack-mounted
equipment should be maintained. Particular attention
should be given to supply connections other than direct
connections to the branch circuit (e.g. use of power strips).
NOTE:
This system has no user serviceable parts.
--SAVE THESE INSTRUCTIONS--
Installation Instructions
Avoid potential personal injuries
Publicidad
Tabla de contenido
