Operation; Before Use - LG SIGNATURE URETC1408N El Manual Del Propietario

OPERATION

Before Use

Clean the refrigerator.
Clean the refrigerator thoroughly and wipe off all dust that accumulated during
shipping.
Open refrigerator doors to ventilate the interior.
The inside of the refrigerator may smell like plastic at first. Remove any
adhesive tape from inside the refrigerator and open the refrigerator doors for
ventilation.
Wait for the refrigerator to cool.
Allow the refrigerator to run for at least two to three hours before putting food
in it. Check the flow of cold air in the freezer compartment to ensure proper
cooling.
The refrigerator makes a loud noise after initial operation.
This is normal. The volume will decrease as the temperature decreases.
CAUTION
• Do not scratch the refrigerator with a sharp object or use a detergent
that contains alcohol, a flammable liquid or an abrasive when removing
any tape or adhesive from the refrigerator. Remove adhesive residue by
wiping it off with your thumb or dish detergent.
• Do not peel off the model or serial number label or the technical
information on the rear surface of the refrigerator.
CAUTION
• Putting food in the refrigerator before it has cooled could cause the food
to spoil, or a bad odor to remain inside the refrigerator.
OPERATION 15