Technical Data; Ordering Replacement Parts - ALPHA-TOOLS AHSS 6 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 9
Anleitung AHSS 6 AlphaTools
GB
Starting up:
Charging the battery pack (Figure 2)
1. Check that your mains voltage is the same as that
marked on the rating plate of the battery charger.
Plug the charger into the socket and connect the
charging cable to the charging jack (10) on the
cordless vacuum cleaner.
2. The red LED indicates that the battery pack is
charging. The time it takes to fully recharge an
empty battery is approximately 8 hours. The
charging time for a partially charged battery is
comparatively less. The temperature of the battery
pack may rise slightly during the charging
operation. This is normal.
Important! When the battery pack is fully
charged the charger does not cut out
automatically.
If the battery pack fails to charge, please check
whether there is voltage at the socket-outlet
whether there is perfect contact to the charging
jack on the cordless hand-held vacuum cleaner.
If the battery pack still will not charge, please send
the power supply unit
and the cordless vacuum cleaner
to our after-sales service department.
To ensure that the battery pack provides long service
you should take care to recharge it promptly. This is
definitely required if you find that the power of the
cordless hand-held vacuum cleaner falls.
Never fully discharge the battery pack. This will
cause it to develop a defect.
Operation (Figure 1)
Take the cordless hand-held vacuum cleaner out of
its mounting (5) and slide the On switch (7) forwards.
The vacuum cleaner will stop automatically when you
release the On switch. The green LED indicates that
the vacuum cleaner is operating. Before you vacuum
any liquids or wet items, empty the dust tank and
clean the filter.
The dust tank (6) can be removed and emptied by
pressing the release button (9). We recommend that
you empty the dust tank after each time you use the
vacuum cleaner.
Filter cleaning (Figure 3)
Clean the dirty filter with soap suds and then hang it
up to dry. Insert the dry filter and start the vacuum
cleaner again.
6
17.02.2004
9:33 Uhr
Seite 6
Ensure that all the individual parts have been
assembled again correctly.

Technical data:

Motor voltage supply
Battery charging voltage
Battery charging current
Charger mains voltage
230 V ~ 50 Hz

Ordering replacement parts

Please provide the following information on all orders
for replacement parts:
Model/type of device
Article number of the device
ID number of device
Replacement part number of the required spare
part
!
iNTERNATiONALES SERViCE CENTER GmbH
Rechargeable batteries and cordless electric
machines and tools contain materials that are potentially
harmful to the environment. Never place any cordless
electric machines or tools in your household refuse.
When cordless electric machines or tools become
defective or worn, remove the rechargeable batteries and
return them to iSC GmbH Eschenstrasse 6, D-94405
Landau, Germany. If the rechargeable batteries cannot
be removed, return the complete cordless machine or
tool. You can then be sure that the equipment will be
correctly
6 V=
9 V=
450 mA

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

23.471.12

Tabla de contenido