Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

C-LOGIC 230
INSTRUCTION MANUAL
Infrared thermometer
Description
Noncontact Themometer detects the infrared ray that
an object emits, The instrument foculizes infrared
energy of the object onto a sensor through a lens,
changes the surface temperature into electric signal,
a microcomputer calculates and displays the
measurement temperature on the LCD.
• Single-spot Laser Sighting
• Backlit Display
• Current Temperature Plus MIN, MAX, AVG
Temperature Displays
• Preset Emissivity 0.95
Warning
• Please read the following information carefully
before using the meter.Protection is impaired if
used in a manner not specified in this manual
• Do not clear the meter using solvents.
• Keep the instrument clean, and do not get dust into
detecting hole.
• Do not point laser directly at eye or indirectly off
reflective surfaces.
• Laser :class 2 <1mW/630-670nm
•Laser radiation is classified according to
IEC 60825-1: 2014-05, Safety of laser products –
Part 1: Equipment classification and requirements.
CAUTION
LASER RADIATION - DO NOT STARE INTO BEAM.
AVOID EXPOSURE - LASER RADIATION IS EMTTED FROM THIS APERTURE .
MAX OUTPUT<1mW, WAVELENGTH 630~670nm, CLASS 2 LASER PRODUCT
WARNING
laser
Laser radiation -
when open do not
stare into beam.
01
Panel
6
7
2
5
8
3
4
9
1
Screen
6
Sensor
Mode key
Laser
2
7
Backlight key
Trigger
3
8
Laser key
9
Battery cover
4
5
°C/°F key
02
Display
1
2
4
3
13
5
12
6
11
10
9
8
7
1
Laser indicator
8
Min value
2
Scan status
9
Max value
3
Emissivity
Average value
10
Low battery
Primary display
4
11
5
°F unit
12
Surface scan
6
°C unit
13
Hold status
Secondary display
7
03
D:S ratio
Unit: mm
1500
900
300
S
30
90
150
D
D (distance):S (spot size) = 10:1
Make sure that the target is larger than the meter's
visual spot size. The smaller the target, the closer you
should be to it. The relationship between distance and
spot size is 10:1
04

Publicidad

loading

Resumen de contenidos para C-LOGIC 230

  • Página 1 C-LOGIC 230 Description Panel Display D:S ratio Noncontact Themometer detects the infrared ray that an object emits, The instrument foculizes infrared Unit: mm INSTRUCTION MANUAL energy of the object onto a sensor through a lens, 1500 changes the surface temperature into electric signal, a microcomputer calculates and displays the measurement temperature on the LCD.
  • Página 2 Operating Thermometer Warranty Note1 Specifications Note3 • To measure temperature, pull and hold trigger. Make sure that the target is larger than the meter's This produt will be free from defects in material and When the battery voltage is lower, the battery symbol visual spot size Temperature Release the trigger to hold a temperature reading.
  • Página 3 C-LOGIC 230 Pantalla Relación D:S Descripción Panel El termómetro sin contacto detecta la energía infrarroja que emite un objeto, el instrumento focaliza esa energía Unidad: mm infrarroja del objeto en un sensor a través de una lente, MANUAL DE INSTRUCCIONES cambia la temperatura de la superficie en señal eléctrica,...
  • Página 4 Funcionamiento del termómetro Garantía Especificaciones Nota1 Nota3 • Para medir la temperatura, apriete y mantenga oprimido Asegúrese de que el objetivo sea más grande que Este producto estará en garantía durante dieciocho meses el tamaño dela zona observada por el termómetro. Cuando la tensión de la batería es baja, aparece el símbolo Rango de el gatillo.