DRILL DOCTOR 350X Guia Del Usuario página 11

1.
2.
Turn the Chuck an even number of half-turns with light
inward pressure:
• 3/32-inch bits—use 2 to 4 half-turns,
• 1/8-inch bits—use 4 to 6 half-turns,
• 3/8-inch bits—use 16 to 20 half-turns.
Note: Use just enough pressure to keep the Cam against
the Cam Guide. Let the machine do the sharpening.
www.drilldoctor.com
Align Guides.
Turn on the Model 350X.
Align either of the Sharpen-
ing Guides on the Chuck with
the Cam Guide and insert the
Chuck in the Sharpening
Port.
Turn until sharp.
Making sure that the Chuck
rests firmly against the Cam
Guide, turn the Chuck one
half-turn to the right—to the
other Sharpening Guide.
Turn from Guide to Guide in a
smooth and even motion until
the bit is sharp. To sharpen
both sides of the bit evenly,
always use an even number
of half-turns. The number of
half-turns needed to sharpen
the bit depends on its size.
Sharpening Guide
Cam Guide
9