Adjusting The Para-Bass Controls - MTX Audio ROAD THUNDER Manual De Instrucciones

ADJUSTING THE PARA-BASS CONTROLS

The bass response in a system is affected by four factors:
1. The acoustics of the vehicle
2. The location of the speakers
3. The music being played
4. The speakers and speaker enclosures
The RTLDBP was developed to help restore any low frequencies lost due to varioations in the
recording process. However, the acoustics of various environments are different.
The SWEEP control allows the user to select a center frequency (the frequency most affected)
between 27 and 63 Hz. The WIDTH control then allows the user to control the shape of the filter
centered around the SWEEP frequency.
SETTING THE BASS OUTPUT CONTROLS
The RTLDBP is a powerful bass component. This device is equipped with several different Bass
Output selections. If the settings need to be changed, please use the chart below for guidance. It is
recommended to listen to the factory setting before changing the Bass Output settings.
Recommended Settings:
Setting Amplifier Input Voltage
2.5V 3V or Less
5V 5V or Less
7.5V 7.5V or Less
10V 10V or Less
FEATURES
Bass Driver - The RTLDBP contains a Bass Driver circuit that accurately recreates and injects low
frequency information back into the signal path. This means that the RTLDBP will give more bass
impact to music sources, even older compact discs and tapes.
Bass Equalization Circuit - The RTLDBP has a unique equalizaition circuit that contours the restored
bass to the speaker systems.
Dash Mount Remote Control - The RTLDBP comes with a Dash Mountable Remote Control that allows
the user to control the bass processor without having to leave the driver's seat. The LED indicator will
become brighter as the bass is increased, and will dim as the bass is decreased.
Bass Maximizer Indicator - These three LED indicators will flash when the bass maximization circuit
has been activated.
PFM Subsonic Filter Switch - This unique feature has the ability to fine tune the bass response of any
system. Why waste power on nasty subsonic information when the PFM Subsonic Filter Switch can
help to clean things up?
Bass Output Control - The RTLDBP has the ability to produce large amounts of deep, mind blowing
bass without damaging the speakers. The Bass Output Control circuit allows the RTLDBP to maximize
the bass output of any audio system while restraining destructive bursts.
Minimum Speaker Size
8"
10"
12"