Changing Batteries - Moehlenhoff Alpha IP Manual De Instrucciones

Alpha IP WTH 61001
26

Changing batteries

Display Meaning
Long lighting in red Transmission error,
transmission limit
reached (duty cycle)
6x long flashing, red Device defective
8 Changing batteries
The symbol in the display and in the Alpha IP app indicates low bat-
tery voltage. Replacing the batteries:
1. Pull the device from the frame and the mounting plate (see fig. 6).
2. Remove the batteries from the back of the device.
3. Insert two new batteries of the type R03/Micro/AAA according to
the marking.
4. Install the interchangeable frame onto the mounting plate.
5. Position the room control unit Display S onto the mounting plate and
latch it into the clips.
9 The display changes to the normal indication.
9 The device is now ready to operate.
DEU ENG FRA
FIN SWE POL
Solution
• Re-send the com-
mand after one
hour at the latests
in case of exceeded
duty cycle.
• Check the device
for defects, e. g.
mechanical block-
ing.
• Eliminate radio in-
terference.
• Observe the indica-
tion in the app.
• Have the device
checked by a spe-
cialist dealer.
• Replace the device.
NDL ITA ESP
RUS
DAN/NOR