Operating Instructions Dru-Art 2 - 6; Lighting; Temperature Controle; Switching Off - Dru Verwarming DRU-ART 2 Manual De Instalación Y Guía Del Usuario

OPERATING INSTRUCTIONS
operatInG InstructIons dru-art 2 – 6
The buttons to operate the appliance have been placed
behind the flap on the heater front.

Lighting

Press and hold button A (with the
symbol ). Press the ignition but-
ton E (with the symbol
or twice to light the pilot burner.
Check that the pilot flame is alight
(behind the glass on the front).
Once the pilot light is burning, hold
button A for another 10 seconds.
Then release button A and check
that the pilot light is still burning.
The main burner could be ignited
by the pilot light immediately after
button A has been released,
depending on the thermostat setting,
button D, and the room temperature.
Temperature control
The thermostat setting, button D, will determine the
temperature in the room. Setting 7 - with '7' opposite the
indicator (C) - will give the highest temperature and set-
ting 1 the lowest. The thermostat regulates the heater in
modulation between hIGh and LOW burner settings and,
if only a little warmth is required, between LOW and N.
The thermostat automatically keeps the room at the
required temperature.
There is absolutely no objection to the appliance staying
on overnight, it is fully protected.
The thermostat has a frost-protection setting. This is
setting N on the thermostat control D. If the ambient
temperature drops below 10 ºC, the valve will automati-
cally open; the heater will then heat the room to 10 ºC.
If this is not required, the heater should be switched off.

Switching off

Press button B (with the symbol o ). The gas supply to
both the main and the pilot burners is then switched off.
operatInG InstructIons
dru-art 8 and 10
The buttons to operate the appliance have been placed
behind the flap on the righthand side of the heater front.
Lighting
Press button A and turn to the left
towards the small flame
At the heater will ignite. Check
if the pilot light burns behind the win-
dow. If the pilot burns, keep
button A pressed fully down for
another 5 seconds. Then release
button A and check if the pilot light
keeps burning. Now turn button A
) once
.
towards the big flame
of the regulation block.
Temperature control
By turning control button B to the left (to mark 7), the
set temperature will rise, by turning the button to the
right (towards mark 1), the set temperature will fall. The
E
thermostat regulates modulatingly between full power
setting and low power setting and keeps the room at the
temperature set by you. The heater can be kept burning
uncontrolled as it is fully protected.
B

Pilot light setting

A
When the heater is not in use, but the pilot light has to
be kept burning, button A can be turned towards the
C
small flame. In this way, the gas supply to the main burner
will be turned off.
D
Switching off
Turn button A towards the "0" setting. The gas supply to
the burners will then be turned off.
A
B
13
. This will open the main valve
DRU - ART