C-LOGIC 510-PC Manual De Instrucciones página 2

INSTRUCTIONS MANUAL
Interruptor crepuscular pared IP54
C-LOGIC 510-PC
SKU: CLOGIC510PC230VCBINT
ENGLISH
This item is an automatic photocell switch for lamps. When the ambient-light darken to the
LUX that you set in advance, the light will turn on. The light will turn off at the preset time or
ambient-light is more than the setting LUX. It adds the functions of LUX adjustable and TIME
setting. It is easy and comfortable to use.
SPECIFICATION
• Power source: 220-240V~
• Power frequency: 50/60Hz
• Rated current: 10A
• Ambient light: <3-500LUX (adjustable)
• Built-in timer: 1-9 hours (adjustable)
• Working temperature: -20~+40ºC
• Working humidity: <93%RH
• IP 54 Protection degree
FUNCTION
• LUX setting: turn LUX knob anti-clockwise to "3"position, the photocell will only work in
• the dark (less than 3LUX). If turn clockwise to "500" position, it will work when the ambient
• light is less than 500LUX.
• TIME setting: you can set the regular working hours of the photocell as needed.
INSTALLATION
• Switch off the power.
• Loose the four screws on the cover and take down the cover.
• Connect the wire with the product as per the connection-wire diagram.
• According to the correct installation place, install the product with the enclosed
• inflated screws.
• Install back the
• Test it.
TIEM SETTING
The LED indicator inside the sensor will flash to display the preset times as following:
• 1 hour: flash one time
• 2 hours: flash two times
• 3 hours: flash three times
• 4 hours: flash four times
• 5 hours: flash five times
• 6 hours: flash six times
• 7 hours: flash seven times
• 8 hours: flash eight times
• 9 hours: flash nine times
• dusk to dawn: rapidly flash ten times
TEST
• Set the LUX knob to "3" position and set time knob to "1h"position.
• When you test in daytime. you should cover a black opaque cloth on the product, after 1
minute, the lamp will be turned on
• When the cloth mantles the detection window of the photocell, the ambient light of the
photocell is less than 3 LUX, the lamp will be on for one hour.
• When you take away this cloth, the lamp will be off automatically.
• When you slide the LUX knob to "500" position, the lamp could be on in the ambient light
less than 500LUX.
NOTE
• In front of the photocell, there should be no obstruction affecting to accept natural light;
• In front of the photocell, there should be no swaying object.
• Don't install the photocell under the light or in the place where the light will be irradiated
to the photocell.
• When lamp is on, another light source irradiate to the photocell, and this light lasts for
more than one minute, the lamp will turn off and the electronic TIMER will stop counting.
The TIMER will recount from the beginning when the light turns on again
• The electronic TIMER will reset when the power is off over 2~5 seconds.
MOUNTING
EN
CONNECTION-WIRE DIAGRAM
TEST
FULL MANUAL DOWNLOAD
MANUFACTURER: MGL International
APAC: MGL GLOBAL SOLUTIONS LTD
info.apac@mgl-intl.com
Flat 4-1, 4/F, No. 35, Section 3 Minquan
East Road. Taipei, Taiwan.
Tel: +886 2-2508-0877
EMEA: MGL EUMAN S.L.
info.emea@mgl-intl.com
Parque Empresarial Argame, 33163
Morcín. Asturias, Spain.
Tel: +34 985-08-18-70
Figura 1 Incorrecto
You can download the complete manual at the URL
https://clogic-intl.com/clogic-510-pc
AMERICAS: MGL AMERICA, LLC.
info.na@mgl-intl.com
US East Coast: 2810 Coliseum Centre
Drive, Ste. 100. Charlotte, North Carolina,
28217 USA
Tel: +1 833 533-5899
US West Coast: 760 Challenger Street.
Brea, California 92821 USA
Tel: +1 310-728-6220
www.mgl-intl.com
Correcto