Attaching The Fan Blades - HAMPTON BAY 728 046 Manual Del Propietário

CLOSE-TO-CEILING MOUNTING
1. Carefully unhook the fan from the mount-
ing plate and align the locking slots of the
ceiling canopy with the two screws in the
mounting plate. Push up to engage the slots
and turn clockwise to lock in place. Imme-
diately tighten the two mounting screws
firmly.
LOCKING SLOTS OF CEILING CANOPY ARE
PROVIDED ONLY AS AN AID TO MOUNTING.
DO NOT LEAVE FAN ASSEMBLY UNATTENDED
UNTIL ALL FOUR CANOPY SCREWS ARE EN-
GAGED AND FIRMLY TIGHTENED.
2. Install the remaining two mounting screws
into the holes in the canopy and tighten
firmly.
3. Install the decorative canopy ring by align-
ing the ring's slots with the screws in the
canopy. Rotate the ring clockwise to lock in
place.
4. You may now proceed to attaching the fan
blades.
8.
Attaching the Blade
Bracket to the Motor
1. Fasten the blade bracket to the motor by
inserting the alignment post into the slot
on the bottom of the motor and tightening
the blade bracket screws. The blade bracket
screws are pre-installed into the blade
bracket (Figure 14).
2. Repeat this step for the remaining blade
brackets.
Alignment Post
Screws
Attaching the
Fan Blades
NOTE: Your
advancements for quick and easy blade
installation.
NOTE: Your fan blades are reversible. Select
the blade side finish which best accentuates
your decor.
1. Mount the fan blades to the blade bracket by
aligning the three key-slot holes in the blade
with the three posts on the top of the blade
bracket (Figure 15a).
2. Hold the blade with both hands close
to the blade bracket and press the blade
down firmly. Ensure the key-slot holes are
properly seated on the blade bracket posts
Slot
(Figure 15a).
Figure 14
fan features revolutionary
Blade with
Key-Slot Holes
Blade Bracket with
Mounting Posts
Figure 15a