GE GBE21D Manual Del Usuario página 29

INSTALLING THE REFRIGERATOR (Cont.)
1 REMOVE THE REFRIGERATOR DOORS (Cont.)
H. Remove the button plugs on the left side of the
cabinet across from where the hinge bracket
was located and install in the holes where the
bracket was removed.
I.
bracket and install
on the left side of the
cabinet where the
button plugs were
removed.
J.
wrench, install the hinge pin into the center
hinge bracket.
For Models With a Freezer DOOR:
F.
G.
remove the hinge pin from
the hinge bracket. The
hinge pin will be used
again on the opposite
side.
H. Remove the tape and tilt the door away from
the cabinet. Lift the door off of the bottom hinge
pin.
I. Using a thing-blade screwdriver remove the
button plug from the top left side of the door
and install it on the opposite side.
J. Set the door on a non-scratching surface with
the inside up.
49-60805-1 Rev. 3
Installation Instructions
K.
ratchet driver, remove
the bolts securing the
center hinge to the
cabinet.
L. Locate the button plugs in the kit and install
them in the opposite side of center hinge.
M.
socket/ratchet driver, install
the center hinge bolt on the
left side of the cabinet and
torque to 60 in-lb.
(6.78 Nm).
N.
go past the bottom of the bracket.
O.
ratchet driver, remove
the screws from
the bottom hinge
bracket. These will
be reinstalled on the
other side. Pull up
on the hinge pin to
remove.
P. Using a Torx T-20
screwdriver, remove the
screw from the cabinet and
install it on the other side.
Q.
ratchet driver, install
the bottom hinge
bracket and torque
the screws to 60
in-lb. (6.78 Nm).
Remount the hinge
and pin in the opposite hole on the cabinet.
29