DeVilbiss PulseDose PD1000 Guía De Instrucciones página 6

OPERATING INSTRUCTIONS
Inserting A battery Into The PulseDose Compact Conserving Device
1
NOTE– When changing
batteries, first turn the rotary
selector to the "OFF" position.
Attaching Your PulseDose Conserving Device To The Cylinder
1
Loosen the knob.
NOTE- Verify that the regulator seal is present and that there are no cuts, tears, or depressions.
Using Your PulseDose Compact Conserving Device
1
Open the cylinder.
EN - 6
2
Open the battery door. Insert 2
"AA" Alkaline or NiMH
batteries (observe polarity).
2
Carefully lower the conserving
device over the post of the
cylinder.
CAUTION: Alignment pins can damage sealing surfaces of the
post increasing the chance of leakage. Align the pins in the
conserving device to the alignment holes in the cylinder post.
2
Attach the standard nasal
cannula to the cannula fitting
and to your nose and face.
Oxygen tubing up to 35 feet
long may be used in
PulseDose delivery mode.
3
Close the battery door.
3
Hand-tighten the knob until the
conserving device is secure.
3
Turn "ON" by turning the
rotary selector to the
prescribed flow setting. Always
confirm that the green and red
lights flash at startup.
A-1000