Ecreso Fm 3000W - 5000W Quick Start Notice; Recommendations Regarding Connections - Worldcast Systems ECRESO FM 3000W Guía Rápida De Inicio

English version
ECRESO FM 3000W - 5000W
Quick start notice

1. Recommendations regarding connections

!
The transmitter should never be operated without a suitable antenna or test dummy load, and an
overall proper installation. Failure to observe this requirement may result in damage to the
transmitter that is not covered by the warranty.
Description of the dongles used for the CAN connections
* The plug is only present on the dongles at the beginning and end of the line.
The CAN connection between all modules will make it possible to cut off the amplifiers if the ECRESO FM
is cut off.
Make sure the safety loops are closed.
If needed, secure the interlock plug with the provided locks as follows:
Make sure to ground the transmitter properly.
!
Make sure all connectors are tightly screwed in before connecting to the mains. Use a wrench as
needed to fasten connectors. A poor connection may create an electrical arc which could destroy
the amplifiers.
4
DB9 port
switch 1**
Interlock plug
switch 2**
B port
locks
A port
plug*