Ovislink Air Live RS-2000 Manual Del Usuario página 13

STEP 5:
When the New Entry option appears, enter the following configuration:
Source Address – select Inside_Any
Destination Address – select Outside_Any
Service - select ANY
Action - select Permit ALL
Click on OK to apply the changes.
STEP 6:
The configuration is successful when the screen below is displayed. Make
sure that all the computers that are connected to the LAN port have their
Default Gateway IP Address set to the Security Gateway's LAN IP Address
(i.e. 192.168.1.1). At this point, all the computers on the LAN network
should gain access to the Internet immediately. If a Security Gateway filter
function is required, please refer to the Policy section in the user manual.
Security Gateway Series
English
1
1
2
2