Operation - Craftsman 580.753000 Manual Del Usuario

HOW TO USE YOUR PRESSURE
WASHER
If you have any problems operating your pressure
washer, please call the pressure washer helpline at
1-800-222-3136.
To Start Your Pressure Washer
To start your engine-powered pressure washer for the
first time, follow these instructions step-by-step. This
starting information also applies whenever you start
the engine after you have let the pressure washer sit
idle for at least a day.
1. Place pressure washer near an outside water
source capable of supplying water at a flow rate
greater than 3.7 gallons per minute and no less than
20 PSI at pressure washer end of garden hose.
2. Check that high pressure hose is tightly connected
to spray gun and pump. See "Assembling Your
Pressure Washer" for illustrations.
3. Make sure unit is in a level position.
4. Connect garden hose to water inlet on pressure
washer pump. Turn ON water.
CAUTION
DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment will result from failure to follow
this instruction.
5. Squeeze trigger on gun to purge pump system of
air and impurities.
6. Place colored quick connect spray tips in slots on
holder that's attached to nozzle extension.
7. Attach nozzle extension to spray gun. Tighten by
hand.
8. Choose spray tip you want to use and insert it into
nozzle extension. See "How to Use Spray Tips" on
page 10.
9. Engage safety latch to spray gun trigger.

OPERATION

10. Rotate fuel shut-off valve to "On" position (fully
11. Move variable pressure control lever to "High"
12. Move choke lever to "Choke" position.
NOTE: For a warm engine, be sure the choke lever is
in the "Run" position.
13. Grasp handle and pull the recoil starter lightly until
14. Return recoil starter slowly. DO NOT let rope
15. When engine starts, slowly move choke lever to
16. If engine fires, but does not continue to run,
17. If engine fails to start after six pulls, move choke
• When starting engine, pull cord slowly until resistance is
• If engine starts and fails to continue to run or if increased
Safety Latch
9
counter-clockwise).
Fuel Valve shown in
"On" position
position, shown on engine as a rabbit.
you feel some resistance, then pull briskly.
"snap back" against starter.
"Run" position as engine warms. If engine falters,
move choke lever to "Choke" position, then to
"Run" position.
squeeze trigger on spray gun to relieve internal
pump pressure. Move choke lever to "Run"
position, and repeat steps 13 through 15.
lever to "Run" position, and repeat steps
13 through 15.
CAUTION
Avoid injury from kickback.
felt and then pull rapidly to avoid kickback.
resistance is felt during starting pull attempts, squeeze
trigger on spray gun.