Tabla de contenido
Publicidad
During this operation, do not:
Damage any internal components.
Scratch the cover.
Damage the air pipe.
Installation
It is suggested that the unit be electrically installed
by means of rear channelling.
The terminal strip to which the mains wiring is
connected, together with the associated entrance
hole (22 mm/0.87" diameter) are located on the
right side of the dryer.
This dryer is a class II appliance and does not
require an earth connection.
The installation procedure is as follows:
1. Drill four 6-mm (0.24") diameter holes using
the supplied template. Clean any dust from
the drilled holes and fully insert the four
supplied plugs flush with the wall surface.
2. Pass the electric wiring from the wall through
the entrance hole (22 mm/0.87" diameter).
3. Screw in the four supplied coach screws to
firmly secure the dryer base to the wall.
4. Connect the electric wire pair to the terminal
strip.
-11-
www.mediclinics.com
Publicidad
Tabla de contenido
