Wedge Interface Connection; Star Modem™ Initial Setup - Datalogic STAR Modem Guía Rápida

WEDGE INTERFACE CONNECTION

Before proceeding with this connection, configure STAR Modem™
software parameters through the RS232 interface and then set the
hardware jumper position (see "STAR Modem™ Configuration").
CAUTION
For Wedge interface connection, it is necessary to use the adapter as shown in the
following figure:
STAR Modem™ INITIAL SETUP
For a correct STAR Modem™ configuration, keep in mind the following guidelines.
When using the modem for the first time, set the desired
STAR Modem™ address via RS232 serial interface, since its factory
default address is "Undefined".
NOTE
For Stand Alone configurations using Wedge/Pen Emulation interface connections,
set all parameters via RS232 interface using either the DL Sm@rtSet software
program or sending configuration strings to STAR Modem™. Then, set the correct
hardware jumper position as indicated in the table given in "STAR Modem™ Setup
For Stand Alone Mode" (see also the figure below).
For changing any configuration parameter in Wedge/Pen Emulation interface
connections, send the new configuration commands via radio using Datalogic RF
devices. Otherwise, set the jumper in the RS232 position (RS232 communication
parameters are set to default values) to send the configuration strings to
STAR Modem™ via serial interface and set the jumper back in the Wedge/Pen
Emulation position to enable this kind of connection.
Datalogic Standard Wedge Cable
90ACC1859
STAR Modem™ Adapter
DATALOGIC
5